Hands-Free Magnetic LED Light
The STKR Concepts Magnetic Light Mine uses a Lumen Tech LED and 12 powerful neodymium (rare earth) magnets that allow you to stick it to any steel surface or rest it on any surface as a tripod or quad-pod and aim the light toward the work-space at almost any angle.
Potential Uses are Endless
Professionals, including automotive technicians, electricians, plumbers and HVAC contractors, will want to have one on hand, as it is small enough to fit into tight areas and aim a powerful beam of light where it is needed most. Because of its 12 neodymium magnets, it also works as a pick up tool for dropped screws, nails and hardware.
Do-it-yourselfers and homeowners will also find hundreds of uses for the STKR Concepts Magnetic LED Light. Use it when working on an engine, changing a tire, wiring a home theater, switching on a breaker, crawling around under a counter or sink. It will stick to the fridge, making it the go-to flashlight for the whole family, and its great to have on camping trips.
Features
Bright LED
12 Neodymium magnets to aim light at many angles
Use as a pick up tool
Back slider on/off switch
Weather resistant
What's Included
Magnetic Light Mine
LR44 batteries included
MSRP $6.99
- Model# 00140
- 15 lumens
- 1 Lumen-Tech white LEDs
- Transparent A.B.S. red body
- 12 Neodymium (rare earth) magnets
- Slider power switch
- Runtime: 10 hours
- 3 LR44 batteries (included)
- Size: 1.6 in. height x 1.5 in. diameter
- Weather resistant
- 1-year warranty
Why won’t my MLM turn on?
The switch on the Light Mine can stick when first being used, so I would first like to make sure that you have it completely pushed over to the “ON” side. Sometimes the switch needs to be pushed over hard, using the butt of your thumb. The switch can click once but needs to click over a little farther to stay on.
Can I change the batteries for the Magnet Light Mine?
While it is possible to change the batteries in the Magnetic Light Mine, please be very careful. Replacing the batteries does run the possibility of damaging the whole unit. Although, if done with care, there should not be an issue.
Pressing on the locking tabs with a flat-head screwdriver will open the body. Pressing too hard will snap/break the locking tab and/or tab receiver, this is the difficult part so be very careful.
The batteries are LR44 alkaline. Silver oxide equivalents (SR44) can be used but do not mix alkaline batteries with silver oxide batteries. (Silver Oxide batteries will last longer but the initial brightness of the LED will be less) When removing the batteries, you will notice they are shrink-wrapped. Your replacement batteries will need to be isolated as well. Clear packaging or electrical tape works well, just leave the ends exposed for the electrical contacts. (Please dispose of batteries properly)
California Prop. 65 WARNING:
This product can expose you to Bisphenol A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.